Sony CDX-F7750S - Manual (Page 11)

11
CDX-F7750S/F7750
2-515-342-21 (1)
H:\Data Disk\2515342211\251534211CDXF7750S\01GB02CD-EUR.fm masterpage:Right H:\Data Disk\2515342211\251534211CDXF7750S\01GB02CD-EUR.fm masterpage:Right
Other functions
Changing the sound settings
Adjusting the sound
characteristics
You can adjust the bass, treble, balance, fader
and subwoofer volume.
1
Select a source, then press (SOUND)
repeatedly to select the desired item.
The item changes as follows:
BASS (bass) t TREBLE (treble) t
BALANCE (left-right) t
FADER (front-rear) t
SUB WOOFER (subwoofer volume)*
* “
∞
” is displayed at the lowest setting, and can be
adjusted up to 20 steps.
2
Rotate the volume control dial
repeatedly to adjust the selected item.
After 3 seconds, the setting is complete and
the display returns to normal play/reception
mode.
Note
Adjust within 3 seconds of selecting the item.
With the card remote commander
In step 2, to adjust the selected item, press
< or , .
Adjusting the equalizer curve
— EQ7 Tune
You can adjust and store the equalizer settings
for different tone ranges.
(With the card remote commander)
1
Select a source, then press (MENU) .
2
Press M or m repeatedly until “EQ7
Tune” appears, then press (ENTER) .
3
Press < or , repeatedly to select the
desired equalizer type, then press
(ENTER) .
4
Press < or , repeatedly to select the
desired frequency.
The frequency changes as follows:
62Hz y 157Hz y 396Hz y 1.0kHz
y 2.5kHz y 6.3kHz y 16kHz
5
Press M or m repeatedly to adjust the
desired volume level.
The volume level is adjustable in 1 dB steps,
from –10 dB to +10 dB.
Repeat steps 4 and 5 to adjust the equalizer
curve.
To restore the factory-set equalizer curve,
press and hold (ENTER).
6
Press (MENU) twice.
The setting is complete and the display
returns to normal play/reception mode.
Adjusting menu items — MENU
You can adjust various menu settings by using
the 4 arrow buttons on the card remote
commander.
(With the card remote commander)
1
Press (MENU) .
2
Press M or m repeatedly until the
desired item appears.
3
Press < or , to select the desired
setting (example: “on” or “off”).
4
Press (ENTER) .
The setting is complete and the display
returns to normal play/reception mode.
Note
Displayed items will differ, depending on the source
and setting.
Tip
You can easily switch among categories by pressing
and holding
M or m .
The following items can be set (follow the page
reference for details):
“
z
” indicates the default settings.
Setup
Clock Adjust (Clock Adjust) (page 4)
CT (Clock Time)
To set “on” or “off” (
z
) (page 9, 10).
continue to next page t
DSPL/PTY
MENU
SCRL
LIST
+
–
ENTER