Samsung DVD-V9500 - Manual (Page 20)

ENG-20
C
O N N E C T I O N S
Connection to an Audio System (Dolby digital, MPEG2 or DTS
Amplifier)
1
Using a coaxial or an optical cable (not included),
connect the DIGITAL AUDIO OUT (COAXIAL) or
DIGITAL AUDIO OUT (OPTICAL) terminal on the
rear of the DVD-VCR to the DIGITAL AUDIO IN
(COAXIAL) or DIGITAL AUDIO IN (OPTICAL)
terminal of the Amplifier.
3
Turn on the DVD-VCR, TV, and Amplifier.
4
Press the input select button of the Amplifier to
select external input in order to hear sound from
the DVD-VCR.
Refer to your Amplifier's user manual to set the
Amplifier's audio input.
Notes
- When you connect the DVD-VCR to DTS Amplifier and play a DTS disc, set the DTS to On in Audio
Setup menu. If it is set to Off, sound will not be heard, or there will be a loud sound.
- Please turn the volume down when you turn on the Amplifier. Sudden loud sound may cause damage
to the speakers and your ears.
- Please set the audio in the menu screen according to the Amplifier. (See pages 57 to 58)
- The position of terminals may vary depending on the Amplifier.
Please refer to the user's manual of the Amplifier.
- Only audio from the DVD player section can be heard when connection is made via the Optical or Coaxial
jack. You must have the analog L and R Audio Out connected to hear VCR audio (see page 19).
2
Using the video signal cable(s), connect the
VIDEO, S-VIDEO or COMPONENT OUT
terminals on the rear of the DVD-VCR to the
VIDEO, S-VIDEO or COMPONENT IN terminal of
your TV as described on pages 14 to 16.
Dolby digital or
DTS Amp.
Coaxial Cable
(not included)