Ej report reading and resetting, A@ 710, A@ 7 – Sharp ER-A242 User Manual

Page 62

Advertising
background image

60

EJ REPORT READING AND RESETTING

The cash register provides an electronic journal (EJ) function. This function is intended to record the journal
data in a memory instead of journal paper, and print the data as an EJ report. The register records the journal
data in REG, PGM, VOID, X1/Z1 and X2/Z2 modes. By default, a maximum of 2000 lines are stored in the
memory, but you can expand it to 3000 lines. For details of EJ programming, please refer to “Electronic Journal
Programming” section (page 45).

Printing journal data on the way of a transaction

You can print journal data of a current transaction recorded in EJ memory by pressing the

R

key during the

transaction.

This function is valid when the printing style is programmed to receipt, and the receipt ON/OFF
function is set to OFF.

• Sample print

Reading and resetting the electronic journal data (Issuing EJ report)

You can read the journal data stored in the EJ memory in the journal format by executing the following
procedure in the X1/Z1 or OP X/Z mode.

• Sample EJ report

• On the EJ memory, a maximum of 2000 (or 3000, if

programmed) lines of data can be stored. When executing all
data reading, all of the data stored in the EJ memory will be
printed. To save paper, compression print is available.

• To stop reading or resetting the data, turn the mode switch to

“MGR” position. The data will not be erased when resetting.

• When printing is performed continuously, the printing may be

intermitted several seconds. After the intermission, the printing
will be restarted.

Header
information
print

7:

P

To reset all of the data:

A

@

710

To read the last 10 records:

A

@

7:

To read all of the data:

A

@

EJ report title

EJ report end title

A242_4 FOR THE MANAGER 06.1.10 5:25 PM Page 60

Advertising