Reduction/enlargement/zoom, Manual – Sharp AR-163 User Manual

Page 19

Advertising
background image

17

MAKING COPIES

REDUCTION/ENLARGEMENT/ZOOM

Reduction/enlargement/zoom

Manual

1

Place the original on the original table and close the
platen cover.

2

Use the PRESET RATIO selector (

,

) keys and the

zoom (

,

) keys to select the desired copy ratio.

To select a preset reduction or enlargement copy ratio, press the
or

key repeatedly until the indicator for the desired copy ratio is

lit.

A.

Preset reduction ratios are: 86%, 81%, 70%, and 50% (95%,
77%, 64%, and 50%).

B.

Preset enlargement ratios are: 115%, 122%, 141%, and 200%
(121%, 129%, 141%, and 200%).

C.

Zoom ratios: Any ratio from 50% to 200% can be set, in 1%
increments. Press the

or

key to set the approximate

ratio, then press the

key to decrease the ratio or the

key

to increase the ratio.

When a zoom (

,

) key is pressed, the ZOOM indicator will light

up and the zoom ratio will be displayed in the copy quantity display
for at least two seconds.

To verify a zoom setting without changing the zoom ratio, press and
hold down the copy ratio display (

) key. When the key is released,

the display will return to the copy quantity display.

To decrease or increase the zoom ratio rapidly, press and hold down
the

or

key. However the value will stop at the preset reduction

or enlargement ratios. To move beyond these ratios, release the key
and then press and hold it down again.

D.

Same-size reset: Press the

or

key repeatedly until the

copy ratio returns to 100%.

3

Ensure that copy paper of the desired size is installed in
the paper tray.

If an optional paper feed unit is installed:
Use the ORIGINAL SIZE ENTER (

) key to select the

original size. Copy paper of the appropriate paper size will be
automatically selected depending on the original size and copy ratio.
If the selected PRESET RATIO indicator or the ZOOM indicator
blinks, the selected copy image is too large for the copy paper size.
The desired paper tray can also be selected by pressing the TRAY
SELECT (

) key.

4

Set the number of copies and press the START (

) key.

Advertising
This manual is related to the following products: