Interrupting a copy run – Sharp AR-163 User Manual

Page 27

Advertising
background image

25

MAKING COPIES

1

Press the INTERRUPT (

) key.

The copier will return to the initial settings.

If this copier has been programmed in the auditing mode using user
program No. 10, “

– – –

” will appear in the copy quantity display.

Enter your account number using the numeric keys. The number of
copies of the interrupt copying will be accumulated against this
account number. See page 13.

When an optional SPF is being used, the copier will stop after
completing the copying of the original which has been fed into the
SPF.

2

When the copier stops, remove the original(s) and set
the original(s) for interrupt copying.

3

Select the desired available copier functions.

4

Set the number of copies.

5

Press the START (

) key.

The interrupt copies will be offset from the previous copies when user
program No. 19 is enabled. See page 35.

6

When all INTERRUPT copies are finished, press the
INTERRUPT (

) key again to cancel the INTERRUPT

mode, and remove the original used for interrupt copying.

The previous copy quantity, copy ratio, copy density, and paper size
will be automatically restored.

7

Replace the original(s) for the interrupted job on the
original table or in the SPF and press the START (

)

key.

INTERRUPTING A COPY RUN

INTERRUPT is used to interrupt a long copy run so that another job can be
done.

SORT or GROUP cannot be selected during interrupt copying. (Sort and
group can be performed only if an optional electronic sorting kit and an
optional SPF are installed.)

Interrupting a copy run

Advertising
This manual is related to the following products: