1 lnb setting, 2 positioner setting – Sony MF68-00258A User Manual

Page 18

Advertising
background image

GB-16

D

I

G

I

T

A

L

S

A

T

E

L

L

I

T

1.1 LNB Setting

You can select the satellite and LNB setting conditions to execute
channel search and you can alter the settings for 22KHz tone.
The parameters set in this menu are needed for programming
the channels for the "Auto scanning" and "Manual scanning".
The necessary information can be found at your antenna and LNB
brochures, or you can ask your dealer.

Select LNB power supply "On".

Select the desired satellite name.

Select the LNB type (frequency).

Select the DiSEqC Mode
(Off, DiSEqC A, DiSEqC B, DiSEqC C, DiSEqC D, Tone Burst A, Tone Burst B)

If you are using a Positioner, select this option. (“Yes” or “No”)

22KHz: In case you are using a dual LNB or two antennas connected to a 22KHz

tone switch box, with the 22 KHz tone switch ("On", "Off" or "Auto") you
can switch between both LNB or antennas.

1.2 Positioner Setting

If you have a DiSEqC 1.2 motorized system which is fully
compatible with DiSEqC1.2, then you can take advantage of the
DiSEqC 1.2 functions available.

Select Satellite.

Select any transponder from above satellites and check out the
Frequency, Symbol Rate, FEC and Polarity.

In case problems arise, ask your dealer.

Select from Menu Mode:

"User" mode :

Enables control of basic positioner function
recommended for beginners. General user uses “User” mode.

"Installer" mode :

This is used to search for the position of a satellite manually.

OPERATING THE RECEIVER

DSR 9500/9510 2.28 3/5/03 3:33 PM Page 16

Advertising