Sony MF68-00258A - Manual (Page 32)

GB-30 D I G I T A L S A T E L L I T
TROUBLESHOOTING
Problem Possible cause Solution of the problem
No display LED on Power cord Power cord plug in correctly
the front panel; not plugged in correctly
No power supply
No pictures on the screen Receiver in Standby mode; Set receiver to "On";
Scart not connected tightly Check connection and correct;
to video output of television;
incorrect channel or video
Check channel and video output and
output selected on television correct (TV instruction manual)
No sound Audio cord connected Check connection and correct;
incorrectly;
Loudness level = 0;
Increase loudness on television set;
Muting active Press the MUTE key
Remote Control does not incorrect operation; Point remote control
operate directly towards the Receiver.
Batteries dead or inserted Replace batteries or insert correctly
incorrectly
Poor picture quality Signal strength to low Check the signal strength in
the "Auto Scan" menu, correct alignment
of your antenna
On-Screen Error Message Antenna cable not connected Check connection and correct;
"Searching for signal" or not tight;
LNB defective;
Change LNB;
incorrect position of the Check position and correct,
satellite antenna; Check the signal strength in
the "Auto Scan" menu
On-Screen Error Message Satellite not yet set Scan of in "Automatic scanning"
"Channel data or "Manual scanning" menu
does not exist."
On-Screen Error Messages: Smartcard: (depend on model)
"Please check the - not plugged in correctly; Check the Smartcard.
Smartcard"; - not plugged in. "Insert the Smartcard."
"Please insert the
Smartcard".
The device, packaging material (e.g. Styrofoam) and the batteries
must never be disposed of with household refuse.
Please obtain appropriate information about the regulations in your community,
and dispose of all refuse in accordance with regulations at the separate
locations provided.
DISPOSAL
DSR 9500/9510 2.28 3/5/03 3:33 PM Page 30