Samsung SW-208 - Manual (Page 5)

7
Connecting the Cables
6
1. Power cable
3. IDE cable
2. Master/slave select terminal
4. Audio cable
1
Connecting the power cable
The 4-pin power cable from the internal power unit of your computer must be
connected to the power terminal on the rear of the CD-R/RW drive.
3
Connecting the IDE cable
Two configurations are possible.
● The CD-R/RW drive is the only IDE device in addition to the hard disk.
4 Connecting the audio cable from a sound card
Connect the 4-pin audio cable between the sound output terminal on the CD-R/RW
drive and the audio input terminal on the sound card.
2
Installing a jumper on the master/slave select terminal
Install the jumper in the correct position on the terminal:
MA to use the device in the master mode
SL to use the device in the slave mode
CS to control the device via a CSEL
host interface signal
See Step 3 for further details.
IDE port
Mother board
CD-R/RW
(SL)
Hard disk
(MA)
Second IDE cable
CD-R/RW
(MA)
CD-ROM
(SL)
Hard disk
(SL)
Hard disk
(MA)
First IDE cable
Mother
board
Install the jumper in the SL position (Slave).
Connect the 40-pin flat IDE cable from the IDE port on the mother board, first to
the CD-R/RW drive and then to the ha
r d disk .
● You already have an additional IDE device installed in your computer.
Install the jumper in the MA position (Master).
Connect the 40-pin flat IDE cable from a second IDE port on the mother
board directly to the CD-R/RW drive or first to another additional IDE drive
and then to the CD-R/RW drive.