Samsung iDCS500 - Manual (Page 28)

Samsung iDCS500 SLT User Guide
–22–
APPOINTMENT REMINDER/ALARM
This feature works like an alarm clock. Use it to remind yourself of an appointment
later in the day (TODAY ONLY) or as a daily reminder every day (DAILY). You can
set up to three alarms. Each one can be either a TODAY ONLY or a DAILY alarm.
n
SET/RESET ALARMS
1. Lift the handset.
2. Dial 15 and then 112.
3. Dial the alarm number 1, 2 or 3.
4. Dial the time you want the alarm to sound. Enter the time as HHMM (hours
and minutes) using a 24-hour clock format (e.g. 1300 for 1pm—see note
below).
5. Dial 1 (TODAY ONLY) or 2 (DAILY) to select the alarm type.
6. Replace the handset.
7. Repeat for each alarm as required.
Note:
•
If you hear an error tone at any time, replace the handset and start again from the
beginning.
•
To set an alarm for midnight (12 am) set the time as 2400
To cancel any alarm you have set, follow the above steps 1–3. Then, dial 00000
and replace the handset.
n
ANSWERING AN ALARM
When the alarm rings, you will hear a series of short rings, repeated three times.
Lift the handset to answer the alarm. If you do not answer, the alarm will alert you
two more times at pre-determined intervals.
IN/OUT OF GROUP
If your station is assigned to a group, this feature allows you to temporarily prevent
your station from receiving any group calls. You will still be able to receive calls that
are dialled directly to your station. Check with your system administrator what the
access code is for this feature and enter it here:
To leave the group:
•
Dial the access code plus the group number (e.g., 501) plus 0.
To re-enter the group:
•
Dial the access code plus the group number (e.g., 501) plus 1.