Woodstock D2485 User Manual

Hot melt glue gun – large, D2485

Advertising
background image

Hot Melt

Glue Gun – Large

SHOP FOX

®

IS A REGISTERED TRADEMARK OF

D2485

265900961

1-800-840-8420

FAX: 360-671-3053

Visit our website @

woodstockinternational.com

Manufactured in China

for Woodstock International, Inc.

HOW TO USE THE GLUE GUN:

1: Plug in gun. Load the glue sticks into the back of the gun.

2: Press trigger several times until the glue stick is firmly set into the inner tube.

3: Allow the glue gun to warm up for approximately 5 minutes.

4: Squeeze trigger until glue flows from the nozzle.

5: Glue need not be spread. Press surfaces together within 15 seconds. Use of clamps or other holding devices is not necessary. Clean surfaces for best bonding.

6: Unplug glue gun when finished. No clean up required. Never pull the glue stick out the back of the gun.

Use

7

16

" glue sticks only.

CAUTION:

Hot melt glue gets hot! Nozzle area temperature reaches 380°. If accidental contact should occur, do not try to remove the glue. Put in cold water immediately.

Advertising