Sharp VL AH 50 H User Manual

Page 3

Advertising
background image

V L - A H 5 0 H / t o b i r a 2 ; 0 0 / 2 / 1 4 / 1 8 : 0 0

G. K . A s s o c i a t e s , To k y o

SPECIAL NOTE FOR USERS IN THE U.K.

The mains lead of this product is fitted with a non-rewireable (moulded) plug incorporating a
3A fuse. Should the fuse need to be replaced, a BSI or ASTA approved BS 1362 fuse marked

or

and of the same rating as above, which is also indicated on the pin face of the plug,

must be used.

Always refit the fuse cover after replacing the fuse. Never use the plug without the fuse cover
fitted.

In the unlikely event of the socket outlet in your home not being compatible with the plug
supplied, cut-off the mains plug and fit an appropriate type.

DANGER: The fuse from the cut-off plug should be removed and the cut-off plug destroyed

immediately and disposed of in a safe manner.

Under no circumstances should the cut-off plug be inserted elsewhere into a 13A
socket outlet, as a serious electric shock may occur.

To fit an appropriate plug to the mains lead, follow the instructions below:

IMPORTANT: The wires in the mains lead are coloured in accordance with the following code:

Blue:

Neutral

Brown: Live

As the colours of the wires in the mains lead of this product may not correspond with the
coloured markings identifying the terminals in your plug, proceed as follows:

— The wire which is coloured blue must be connected to the plug terminal which is marked N

or coloured black.

— The wire which is coloured brown must be connected to the plug terminal which is marked

L or coloured red.

Ensure that neither the brown nor the blue wire is connected to the earth terminal in your three-
pin plug.

Before replacing the plug cover make sure that:

— If the new fitted plug contains a fuse, its value is the same as that removed from the cut-off

plug.

— The cord grip is clamped over the sheath of the mains lead and not simply over the lead

wires.

IF YOU HAVE ANY DOUBT, CONSULT A QUALIFIED ELECTRICIAN.

This VIEWCAM does not have a PCM recording or playback function. PCM recordings made
using other VCRs or audio dubbing cannot be played back on this unit.

NOTE:
The VIEWCAM’s LCD panel is a very high technology product with close to 90,000 thin-film
transistors*, giving you fine picture detail. Occasionally, a pixel may appear on the screen as a
fixed point of blue, green, red, or black. Please note that this does not affect your VIEWCAM’s
performance.

If you record on a tape on which PCM sound has already been recorded, the audio track of the
new VIEWCAM recording may not come out if the tape is played back on a PCM-capable VCR.
If this occurs, set the VCR’s audio monitor select switch to the “Standard” position.

*Specifications are subject to change without notice.

Your VIEWCAM is designed to record in SP mode only. It will not perform normal playback for
programmes prerecorded in LP mode.

Advertising