Symbol Technologies LS 2106 - Manual (Page 29)

4-9
Parameter Menus
Laser On Time
This parameter sets the maximum time decode processing continues during a scan attempt.
It is programmable in 0.1 second increments from 0.5 to 9.9 seconds.
To set a Laser On Time, scan the bar code below. Next scan two numeric bar codes beginning
on page
4-57 that correspond to the desired time on. Single digit numbers must have a leading
zero. For example, to set a Time On of .5 seconds, scan the bar code below, then scan the “0”
and “5” bar codes. If you make an error, or wish to change your selection, scan the CANCEL
bar code on page
4-59 .
LASER ON TIME