Symbol Technologies LS 2106 - Manual (Page 3)

vi
LS 2106 Product Reference Guide
Accessories
Standard Accessories
Cables
Optional Accessories
Technical Specifications
LS 2106 Signal Descriptions
Beeper Indications
Chapter 4. Parameter Menus
Introduction
Default Parameters
Set Default Parameter
Beeper Volume
Laser On Time
Power Mode
Beep After Good Decode
Do Not Beep After Good Decode
Transmit “No Read” Message
Do Not Transmit “No Read” Message
Decode Redundancy
Autodiscriminate Response Time
Enable/Disable UPC-E/UPC-A
Enable/Disable EAN-8/EAN-13
Enable/Disable Bookland EAN
Decode UPC/EAN Supplementals
Transmit UPC-A/UPC-E Check Digit
UPC-A Preamble
UPC-E Preamble
Convert UPC-E to UPC-A
EAN Zero Extend
EAN Zero Extend Code Type
Enable/Disable Code 128
Enable/Disable UCC/EAN-128
Enable/Disable Code 39
Code 39 Check Digit Verification
Transmit Code 39 Check Digit
Do Not Transmit Code 39 Check Digit
Enable/Disable Code 39 Full ASCII
Code 39 Buffering (Scan & Store)
Buffer Data
Clear Transmission Buffer
Transmit Buffer
Overfilling Transmission Buffer