Symbol Technologies LS 2106 - Manual (Page 8)

1-3
Setting Up the LS 2106
Setting Up the LS 2106
Installing the Cable
Insert the cable into the receptable on the bottom of the scanner, as shown below:
Figure 1-2. Installing the Cable
Switching Cables
Different cables are required for different hosts. To change the scanner cable:
1. Press the tab on the cable with a small screwdriver.
2. Pull the cable out of the receptacle on the bottom of the scanner.
3. Insert a new cable in the receptacle. Press the cable into the receptacle until you hear
a click.