Samson Txm16 - Manual (Page 15)

50 - FREQUENCY – control knob
The TXM mixers have a onboard Low Pass Filter to make it
simple to connect a subwoofer. Use the FREQUENCY con-
trol to adjust the crossover point for the Low Pass Filter in a
range of 20 Hz to 200 Hz. The FREQUENCY control knob is
active when the SUBWOOFER ON/OFF switch is set to ON.
51 - SUBWOOFER ON/OFF – switch
Used to engage the Low Pass Filter and turn the MONO
output into a subwoofer output.
52 - AFL - switch
The MONO output’s AFL, or After Fader Listen switch allows
you to listen, or “solo” the MONO in the headphones. When
the MONO AFL switch is pressed down, the left/right mix
will be heard in any optional headphones plugged in to
the PHONES connector located in the front panel jack field.
Since the signal is sent after the MONO level fader, you
hear the signal with the added gain from the MONO Level
control.
53 - MONO - Level fader
The MONO level fader control is used to adjust the volume
of the signal connected to the MONO/SUB output.
MAIN Output Section
Controls and Functions




54 - PEAK LEDs
The left and right PEAK LED’s illuminate when the signal
from the MAIN mix is beginning to reach a level where
distortion occurs. If the PEAK lights stay on, your mix is
too hot and you need to lower the MAIN mix volume. It is
okay for the PEAK light to occasionally light, however they
should go off quickly and not stay on.
55 - LED VU METER
The OUTPUT LEVEL METER allows you to monitor the level
of the signal, which is being sent to the MIX OUT jacks.
NOTE: To avoid distortion, adjust the MAIN level control so
that the 0 indicator LED lights occasionally.
56 - AFL (MAIN MIX) – switch
The MAIN MIX output’s AFL, or After Fader Listen switch
allows you to listen, or “solo” the MAIN MIX in the head-
phones. When the MAIN MIX AFL switch is pressed down,
the left/right mix will be heard in any optional head-
phones plugged in to the PHONES connector located in
the front panel jack field. This allows you to listen to the
stereo mix , (let’s say), to check that a signal is not distort-
ed before it gets to the power amplifier. Since the signal
is sent after the MAIN MIX level fader, you hear the signal
with the added gain from the MAIN MIX Level control.
57 -MAIN MIX (left and right) - Level fader
The MAIN MIX Level fader adjusts the level of MAIN left
and right stereo mix.
ENGLISH
11