Samsung SV-661B - Manual (Page 18)

For information about starting the projector and computer, go to “Starting up
the projector and adjusting the image” on page 10.
Connecting a video player
Use the following procedure to connect a video player.
If your video player uses a round, one-prong composite video connector,
you’ll need only the audio cable, audio adapter, and composite video cable
that comes with the projector. If your video player uses a round, four-prong
S-video connector, you’ll need an S-video cable in addition to the audio cable
and audio adapter. See “Accessories” on page 36.
1. Plug the yellow connector of the composite video cable into the
“video-out” connector on your video player. This connector might be
labeled “To Monitor.” Or, if you are using an S-video cable, connect it to
the “S-video out” connector on the video player. Refer to the following
two illustrations.
2. Plug the other yellow connector into the composite video connector on the
projector. Or, if you are using S-video, plug the other end of the cable into
the “S-video” connector on the projector.
Note: HDTV sources must be connected to the projector using the M1-DA
computer cable (not a composite or S-video cable). See the previous
pages for details on connecting this cable.
1 Composite video cable 2 Audio cable 3 Audio adapter
8 iL2120 IBM Value Data/Video Projector, iL2220 Conference Room Data/Video Projector: User’s Guide