Ski-Doo WAKE Series - Manual (Page 121)

MONITORING SYSTEM
PILOT
LAMPS (ON)
MESSAGE DISPLAY DESCRIPTION
OIL Low oil pressure
-
MAINTENANCE
SUPERCHARGER
Maintenance on supercharger required
- SENSOR Sensor failure (vehicle electronic equipment)
- KEY Invalid DESS key
- L KEY DESS learning key active
NOTICE Running engine with low oil pressure may severely damage the
engine.
Beeper Code Information
BEEPER CODES DESCRIPTION
Bad DESS system connection.
Reinstall DESS key correctly over post.
Wrong DESS key.
Use a DESS key that has been programmed for the
watercraft.
Defective DESS key.
Use another programmed DESS key.
Dried salt water in DESS key.
Clean DESS key to remove salt water.
Defective DESS post.
Refer to an authorized Sea-Doo dealer.
1 Long Beep
(while installing DESS
key on watercraft post)
Improper operation of ECM or defective wiring
harness.
Refer to an authorized Sea-Doo dealer.
1 Short Beep
followed by 1 long beep
ECM has been mistakenly set to onboard diagnostic
mode.
Remove and reinstall DESS key.
4 Short Beeps
at different interval for
4 hours
DESS key has been left on its post without starting
engine or after engine was stopped.
To prevent battery discharge, remove the DESS key from
its post.
Watercraft is upside down.
Turn watercraft upright. Refer to
SPECIAL PROCEDURES .
A 2 Seconds Beep
every 15 minutes interval
Engine management system fault.
Refer to an authorized Sea-Doo dealer.
______________
119