Typical — all models except gti, Throttle cable, Throttle cable inspection – Ski-Doo WAKE Series User Manual

Page 92: X package, Others, Throttle cable lubrication, Fuses, Fuse removal/inspection, Warning

Advertising
background image

MAINTENANCE PROCEDURES

smo2008-001-052_a

TYPICAL — ALL MODELS EXCEPT GTI

1. Fitting

Throttle Cable

Throttle Cable Inspection

Depress and release throttle lever
or finger throttle. It should operate
smoothly and return to its initial po-
sition without any hesitation. There
must be a small amount of free-play
when released. Refer to an authorized
Sea-Doo dealer if necessary.

NOTICE

Never attempt to adjust

the idle speed through the throttle
body tamper proof screw. If so, it
would impair the idle speed stabil-
ity. Besides, no adjustment could be
performed by the dealer nor the fac-
tory to correct the idle speed. The
throttle body would need to be re-
placed at the customer's expense.
Also take into account that might
change the engine emission level
and the engine might not meet the
EPA/CARB requirements.

WARNING

Do not alter or tamper with throttle
cable adjustment or routing.

WARNING

If throttle lever or finger throttle
does not automatically return, do
not operate watercraft and see
your authorized Sea-Doo dealer.

smo2008-001-009_b

X PACKAGE

1. Should move freely
2. Slight free-play must be present here

smo2008-001-008_b

OTHERS

1. Should move freely
2. Slight free-play must be present here

Throttle Cable Lubrication

Lubricate the throttle cable with XP-S
Lube or equivalent.

Fuses

Fuse Removal/Inspection

If an electrical problem occurs, check
the fuses. If a fuse is burnt, replace by
one of the same rating.

Use the fuse remover/installer in-
cluded in the fuse box to ease fuse
removal.

90

______________

Advertising
This manual is related to the following products: