Ride plate and water intake grate, Ride plate and water intake grate inspection, Typical — inspect these areas – Ski-Doo WAKE Series User Manual

Page 94: Ski/wakeboard post (if so equipped), Ski/wakeboard post inspection, Ski/wakeboard post lubrication, Body and hull, Body and hull cleaning

Advertising
background image

MAINTENANCE PROCEDURES

Ride Plate and Water Intake
Grate

Ride Plate and Water Intake Grate
Inspection

Inspect ride plate and jet pump water
intake grate for damage. Have dam-
aged parts repaired.

WARNING

The DESS key should always be
removed from its post prior to in-
specting the intake grate.

F18J04Y

2

1

TYPICAL — INSPECT THESE AREAS

1. Water intake
2. Ride plate

Ski/Wakeboard Post
(if so equipped)

Ski/Wakeboard Post Inspection

Check ski/wakeboard post operation.
Ensure it slides up and down easily.
Check locking mechanism operation.
Check fasteners tightness. If some-
thing is found defective, don't use
ski/wakeboard post and see an autho-
rized Sea-Doo dealer for repair.

Ski/Wakeboard Post Lubrication

Lubricate ski/wakeboard post through
all its length. Pull out then push in sev-
eral times to distribute the lubricant.

Body and Hull

Body and Hull Cleaning

Occasionally, wash the body with wa-
ter and soap (only use mild detergent).
Remove any marine organisms from
engine and/or hull. Apply non- abrasive
wax such as silicone wax.

NOTICE

Never

clean

fiberglass

and plastic parts with strong deter-
gent, degreasing agent, paint thin-
ner, acetone, etc.

Stains may be removed from seat and
fiberglass with Knight's Spray-Nine
from Korkay System Ltd or the equiva-
lent.

To clean the carpets, use 3M™ Citrus
Base Cleaner (24 oz spay can) or the
equivalent.

Respect the environment by ensuring
fuel, oil or cleaning solutions do not
drain into the waterways.

WARNING

Periodically verify seat(s) lock pin
and tighten if needed. Make sure
seat(s) securely latches.

92

______________

Advertising
This manual is related to the following products: