Sennheiser Diversity Receiver EK 100 G3 - Manual (Page 10)

9
Using the diversity receiver
Using the diversity receiver
To establish a transmission link, proceed as follows:
1. Switch the diversity receiver on (see next section).
2. Switch a transmitter on (see the instruction manual of the transmitter).
The transmission link is established and the receiver’s RF level display
“
RF ” ቢ reacts.
If you cannot establish a transmission link between transmitter and
receiver, read the chapter “Synchronizing a transmitter with the diversity
receiver” on page 19.
Switching the diversity receiver on/off
̈
Push the two battery compartment catches
µ
and open the battery
compartment cover
¾
.
To switch the diversity receiver on :
̈
Press the ON / OFF button ¹ .
The red ON LED » lights up and the standard display “ Frequency/
Name ” appears on the display panel.
To switch the diversity receiver off :
̈
Keep the ON / OFF button ¹ pressed until “ OFF ” appears on the display
panel.
The red
ON LED » goes off and the diversity receiver switches off.
It is vital to observe the notes on frequency selection on page 19.
When in the operating menu, pressing the ON / OFF button
¹
will
cancel your entry (ESC function) and return you to the current
standard display.
¹
»
¾
µ
µ