Sennheiser Diversity Receiver EK 100 G3 - Manual (Page 8)

7
Putting the diversity receiver into operation
Putting the diversity receiver into
operation
Inserting the batteries/accupack
For powering the diversity receiver, you can either use two 1.5 V AA size
batteries or the rechargeable Sennheiser BA 2015 accupack or the DC 2
power adapter (see “Accessories” on page 23).
̈
Open the battery compartment by pushing the two catches µ in the
direction of the arrows and open the cover ¾ .
̈
Insert the two batteries or the accupack as shown above. Please
observe correct polarity when inserting the batteries/accupack.
̈
Close the battery compartment by pressing on the center of the
cover
¾ .
The battery compartment cover ¾ locks into place with an audible
click.
Charging the accupack
To charge the BA 2015 accupack:
̈
Insert the diversity receiver into the L 2015 charger (see “Accessories”
on page 23).
Mounting the diversity receiver to a camera
Use the supplied CA 2 camera adapter to mount the receiver to a camera’s
flash mount.
̈
Determine where on the perforated plate ƹ the flash mount
adapter ƺ will need to be fastened so that the receiver can best be
attached to the camera.
̈
At this position, place a square nut
ƻ
under the perforated plate
ƹ
.
̈
Fasten the flash mount adapter ƺ to the perforated plate ƹ using the
square nut ƻ .
The L 2015 charger can only charge the combination BA 2015
accupack/diversity receiver. Standard batteries (primary cells) or
individual rechargeable battery cells cannot be charged.
¾
¾
´
µ
ƹ
ƺ
ƻ