Sony MAV-555 User Manual
Page 15
ST300 SETUP
Press Softkey beneath ClearCues to clear all Cue Points to 00:00:00:00.
Press Softkey [YES] when asked “Are You Sure?”
Press Softkey beneath SetDefault to set ST300 to default settings.
Press Softkey [YES] when asked “Are You Sure?”
DISPLAY
SOFTWARE
VERSION
The version number for the currently installed software is displayed.
SYNC
Set to ON if black burst is supplied to the Ref Video connector on the rear
panel. Set to OFF if no black burst is supplied.
VIDEO STANDARD
Sets Video Standard option to NTSC when [NTSC] is pressed.
OR
Sets Video Standard option to PAL when [PAL] is pressed.
RECALL MODE
Press [NORMAL] or [REDIR] (redirect).
NORMAL –
The cue point will load on the learned VTR.
REDIR –
When one and only one clip is learned into a Cue Point, the Clip will be
REDIRECTD to load on the currently selected VTR.
PARITY
In hardware version 3.0 only, set the parity to the same as the switcher.
For hardware versions 2.0 and 2.1, no adjustment is provided or required.
RECORD
Press Softkey to select single button or 2-button record.
RECORD = [REC] Only OR [REC] + [PLAY].
PBIO ADDRESS
Select to match the switcher output. (ALL hardware versions)
SWITCHER TYPE
Select to match the switcher type. (ALL Hardware versions)
TRANSMIT CUELIST
Transmit cuelist to another ST300 or to a PC.
RECEIVE CUELIST
Receive cuelist from another ST300 or PC.
ST300 SETUP
Clear Cues
SetDefault
15
4000CL-MAV, 250 Clip Fast Access System, for Sony MAV-555, with PBIO option