Sony MZ-R910 - Manual (Page 94)

94
MZ-R910.3-234-699-01(1)
B MD playing
Playing an MD right away!
See the illustrations in Japanese text (page 21).
If you want to use the rechargeable battery,
be sure to recharge them before playing
(page 91).
1 Insert an MD.
1
Press OPEN to open the lid.
2 Insert an MD with the label side
facing front, and press the lid to close.
2 Start playing.
1
Press N on the recorder. Turn the
control towards N> on the
remote control.
A short beep sounds in the
headphones/earphones.
2 Press VOLUME +/– on the recorder
to adjust the volume. Pull and turn
the control towards VOL + or
towards VOL – on the remote control.
To stop play, press x.
After you press x to stop, the recorder will
automatically turn off in about 10 seconds
(when using batteries) or about 3 minutes
(when using AC power adaptor).
Playback starts from the point you last
stopped playing. To start playback from the
beginning of the disc, press N for 2 seconds
or more on the recorder, or turn and hold the
control towards N> for 2 seconds or more
on the remote control.
To Do this
Find the
beginning of the
current track
1)
Press .. Turn the
control towards . on
the remote control.
Find the
beginning of the
next track
2)
Press >. Turn the
control towards N>
on the remote control.
Go backwards
while playing Keep pressing ..
Turn and hold the
control towards . on
the remote control.
Select the track
directly viewing
the track number
or name. Turn the jog dial and
press to enter.
Go forward
while playing Keep pressing >. Turn
and hold the control
towards > on the
remote control.
Pause Press X. Press X on the
remote control. Press X
again to resume play.
Remove the MD Press x. Press x on the
remote control. Then
press OPEN to open the
lid.
3)
1) If you press . twice continueously while
playing the first track of the disc, the
recorder goes to the beginning of teh last
track on the disc.
2) If you press > during the last track of the
disc, the recorder goes to the beginning of
the first track on the disc.
3) Once you open the lid, the point to start play
will change to the beginning of the first track
(except when the disc information has been
stored in the Personal Disc Memory).
If the playback does not start
Make sure the recorder is not locked. If it is
locked, slide the HOLD switch in the opposite
direction of the arrow.
Suppressing the skips of the sound (G-
PROTECTION)
The G-PROTECTION function was developed
to provide a higher level of shock resistance
than that of existing players in order to allow
the recorder to be used while jogging.
Note
The playback sound may skip if:
• the recorder receives stronger continuous
shock.
• a dirty or scratched MiniDisc is played.
When using the headphones/earphones
connect them directly to the recorder
1 Press the jog dial
2 Turn the dial until “AUDIO OUT” flashes
in the display, and then press to enter.
3 Turn the jog dial until “HeadPhone” appears
in the display, and then press to enter.
02.4.30, 11:34 AM 94