Sony MZ-R910 - Manual (Page 98)

98
MZ-R910.3-234-699-01(1)
Notes
• The setting will remain even after the power
is turned off.
• If you start recording while the recorder is in
play-paused, the recording will begin from
the point at which it is paused even when
the “REC-Posi” is set to “From End”.
Recording from a microphone
See the illustration in Japanese text (page 29).
1 Connect a stereo microphone (ECM-717,
ECM-MS907, ECM-MS957, etc., not
supplied) to the MIC (PLUG IN
POWER) jack.
2 Press and slide REC to the right.
To select microphone sensitivity
1 Press the jog dial while the recorder is
stopped.
2 Turn the dial repeatedly until “MIC
SENS” flashes in the display, and then
press to enter.
3 Turn the jog dial repeatedly to select
“SENS HIGH” (when recording a soft
sound or a sound in the distance) or
“SENS LOW”(when recording a loud
sound or a sound at close range), and
then press to enter.
Notes
• The recorder automatically switches input in
the following order; optical input,
microphone input, and analog input. You
cannot record through the microphone
while an optical cable is connected to the
LINE IN (OPT) jack.
• The microphone may pick up the operating
sound of the recorder itself. Use the
microphone away from the recorder in such
cases. Please note that the sound of recorder
operations may be picked up if the
microphone that you use has a short
connector.
• Only the left-channel sound is recorded
when a monaural microphone is used.
Adding track marks
automatically at specified
intervals (Auto Time Stamp)
See the illustration in Japanese text (page 29).
Use this feature to add track marks
automatically at specified intervals when
recording through the analog input
connector or a microphone.
1 While the recorder is recording or in
recording pause, press the jog dial.
2 Turn the jog dial repeatedly until “TIME
MARK” flashes in the display, and then
press to enter.
3 Turn the jog dial repeatedly until the
desired time interval flashes in the
display, and then press to enter.
Select one of the following intervals:
“OFF”
“5 min. ON” (track marks are added in
every 5 minutes.)
“10 min. ON” (track marks are added in
every 10 minutes)
“15 min. ON” (track marks are added in
every 15 minutes)
To cancel the setting, select “OFF” in this
step.
Notes
• Automatic track marking by Auto Time
Stamp starts when you add a normal track
mark to the disc (i.e., by pressing T MARK
or X, etc.).
• The setting will be lost when the recording
stopped.
Adjusting the recording level
manually (Manual Recording)
See the illustrations in Japanese text (pages 30
and 31).
When you record, the sound level is
adjusted automatically. If necessary, you
can set the level manually during both
analog and digital recording.
1 While holding down X, press and slide
REC to the right.
The recorder stands by for recording.
02.4.30, 11:34 AM 98