Sony MZ-R910 - Manual (Page 99)

99
Operating Instructions
MZ-R910.3-234-699-01(1)
2 Press the jog dial.
3 Turn the jog dial until “RecVolume”
flashes in the display, and then press to
enter.
4 Turn the jog dial until “ManualREC”
flashes in the display, and then press to
enter.
To switch back to the automatic level
adjustment, select “Auto REC” in this
step.
5 Play the program source.
6 While observing the level meter in the
display, adjust the recording level by
turning the dial.
Set the level so that the meter segments
light up between A (the fifth segment)
and B (the ninth segment). If the level
meter lights up to the right of B, reduce
the input level.
The upper level meter shows the L
channel input level and the middle
meter shows the R channel input level.
If your source is an externally connected
component, be sure to cue the source to
the begining of the material to be
recorded before you start playback.
7 Press X again to start recording.
Notes
• If you press x during recording operation,
the recorder will revert to automatic
recording level adjustment mode the next
time you start a recording operation.
• “RecVolume” cannot be selected in step 2
during synchro-recording. To set the
recording level manually during synchro-
recording, do the procedure below.
1 Do 1 and 2 of “Record and MD” (step 3 of
“Recording an MD right away!) (page 92))
and select “SYNC OFF” in 3.
2 Do steps 1 to 6 of manual recording
procedure. Then do the procedure of
“Record and MD”(step 3 of “Recording an
MD right away!) (page 92)) again.
Recording starts automatically whenever the
source sound is played.
Setting the clock to stamp the
recorded time
See the illustrations in Japanese text (page 33).
To stamp the date and time on the MD
when you record, you first need to set the
clock.
1 Press the jog dial while the recorder is
stopped.
2 Turn the jog dial until “OPTION”
flashes in the display, and then press to
enter.
3 Turn the jog dial until “CLOCK SET”
flashes in the display, and then press to
enter.
The digits of the year flash.
4 Change the current year by turning the
jog dial and press to enter.
The digit of the month flash.
5 Repeat steps 4 to enter the current
month, date, hour, and minute.
When you press the jog dial to enter the
minute, the clock starts operating.
If you make a mistake while setting the
clock
Press . to go back wrongly entered
item, and then enter the correct value. You
can skip a step by pressing >.
To display the current time
On the recorder
1
When the recorder is not operating or
while recording, press the jog dial.
2 Turn the dial until “DISPLAY” appears
in the display, and then press to enter.
3 Turn the jog dial until “Clock” flashes in
the display, and then press to enter. The
current time appears in the display.
On the remote control
1
Press DISPLAY repeatedly until current
time appears in the display.
To display the time in the 24-hour
system
Press T MARK while setting the clock. To
change the clock to the 12-hour system,
press T MARK again.
02.4.30, 11:34 AM 99