Sunbeam SM8650 - Manual (Page 10)

8
Using your StickMaster
Important: Ensure that the stick mixer is
unplugged from the power outlet before
assembling or removing attachments.
1. Insert the motor housing into the hole on
the top of the shaft until you hear a click.
See figure 1.
2. Plug the power cord into a 230-240 volt
power outlet and turn the power on.
3. Lower the stick mixer into food and
depress the power button (I) or (II) at the
top of the motor housing. Setting (I) is low
speed and setting (II) is high speed (for
models SM6200 and SM6400).
Or, with your StickMaster Pro (SM8650),
you can select the optimal speed for
the processing task, by turning the
speed control dial from 1 to 5 and then
depressing the power button (I). Speed one
on the speed control dial is the slowest and
speed five is the fastest.
Note: All stick mixers are designed to
operate only when the power buttons remain
depressed.
4. For an extra boost of power during
operation, the turbo speed button (II) may
be depressed (for model SM8650).
Note: The power button (I) should be released
when selecting turbo speed.
5. To stop the stick mixer, take your finger off
the power button or the turbo speed button
(for model SM8650).
6. To detach the shaft, push the buttons
at either side of the base of the motor
housing until the two pieces separate.
See Figure 2.
Figure 1
Figure 2