Sony PCWA-A500 - Manual (Page 24)

24
Precautions when mounting the Access
Point on a wall
When mounting the Access Point on a wall, the screw size and spacing of
mounting holes is as follows. Note that no brackets are provided for
mounting the Access Point on a wall.
Use screws or nails that meet the following requirements.
Notes
• Using two screws or other fasteners, ensure that the Access Point is securely set on the
wall. When fastening the Access Point to a wall with screws, retighten them after
mounting the Access Point.
• Select a location that will hold the weight of the Access Point when mounting it on the
wall. If the location cannot hold the weight of the Access Point, the Access Point may
drop and cause an accident.
• When mounting the Access Point on walls made of plasterboard or other fragile
material, make sure that the material is strong enough to support the unit’s weight and
use special screw fasteners or other fixtures that are made for use with that material. If
the unit is fastened with ordinary screws, there is a danger that it may fall.
• When mounting the Access Point on the wall, be careful not to drop the Access Point or
the tools used for doing the work. Dropping the unit or tools could result in
unforeseeable accidents.
Hanging the Access Point from screws set in a wall:
Head diameter: 0.24 to 0.29 inches (6.0 to 7.5 mm)
Body diameter: 0.14 to 0.15 inches (3.5 to 4.0 mm)
Length: 1.2 inches (30 mm) or more
2.82 inches (71.5 mm)