Sharp IM-DR400E - Manual (Page 15)

15
IM-DR400E
1
2
3
4
5
6
03/7/21 IM-DR400E_2.fm IM-DR400E TINSE0562AWZZ
Pr
ep
ar
ati
o
n
-B
ef
o
re Reco
rd
in
g
-
Before Recording
" About the TOC
Whilst recording or editing, "TOC" (Table Of Contents)
appears. If you stop recording or turn off the power after
editing, TOC will be written on the MD ("TOC" will flash
followed by "TOC EDIT!"). During the process, the lid is
locked and you cannot remove the MiniDisc.
Warning:
If the power is removed (Battery/AC adaptor) whilst
"TOC" is displayed, the MiniDisc unit lid will remain
locked until the battery/main power is restored and
the unit is turned on. Your new recordings or edited
changes will be lost and your MiniDisc may become
unusable.
Caution:
Whilst "TOC" or "TOC EDIT!" is displayed, follow the
instructions below.
Otherwise, tracks may not be recorded properly.
" To prevent recorded MiniDiscs from
being erased accidentally
Slide the accidental erase prevention tab, located on the
side of the MiniDisc, in the direction indicated by the
arrow.
The MiniDisc will then be protected against accidental
erasure.
To add a recording to such a MiniDisc, slide the acciden-
tal erase prevention tab back to its original position.
" Helpful tip when attaching a label
When attaching a label to a MiniDisc cartridge, be sure to
note the following. If the label is not attached properly, the
MiniDisc may jam inside the unit and you may not be able
to remove it.
TOC display
- Do not jerk or bump the unit.
- Do not unplug the AC adaptor.
- Do not remove the battery.
- Do not subject the unit to shock.
! If the label peels off or partially lifts
away, replace it with a new one.
! Do not put a new label on top of an ex-
isting one.
! Attach the label only in the specified
location.
Recording
prevented
Recordable
3