Samsung 400TS-3 - Manual (Page 57)

Touchscreen
Installing the Touchscreen Driver
1. Connect the monitor to your PC using the USB cable.
2. Insert the driver installation CD into the CD-ROM drive.
3. Click on "HidSetup". The driver installation will start automatically. (Double-click on the file in
the "Touchscreen Driver" folder.)
4. Complete the remaining installation steps according to the instructions displayed on the screen.
Note
At this point, the driver has been installed and the system will automatically retrieve the driver.
However, some computers need to run the following steps to find the new driver: 5, 6, 7.
5. Choose "No, not this time,” and then “Next” (FIG. 1).
FIG. (1)
6. The system tells you that you need to find the relevant driver document if the touchscreen is found.
Please choose “Install the software automatically (Recommended)” and then “Next” (FIG. 2).
FIG. (2)
7. Click "Finish” (FIG.3) to complete the driver update. A taskbar balloon at the bottom, right corner
of the screen will read "Found New Hardware" (FIG. 4).
Using the Software