Samsung BSP-4007 User Manual

Page 20

Advertising
background image

19

Taking a Blood Pressure Measurement

Taking a Blood Pressure

Measurement

Sit upright in a chair with feet flat on the floor.

a.

Wrap the cuff around the arm (refer to previous
page)

b.

Press "

" or "

" button to select a particular

memory zone then press the "START/STOP"
button to start the measurement. The monitor
will automatically inflate to the level that is
right for you.

c.

When taking repeat measurements, make sure to select the same
memory zone before pressing "START/STOP", so the measurement is
registered to the appropriate memory.

*

If the result of your Systolic or Diastolic rate of your reading
result is higher than (not equal to) your set personalized
level the DIGIT will flash. In addition the measurement that
is out of range, either Systolic or Diastolic, will flash. If both
are out of range both will flash.
If the result of your Systolic or Diastolic rate of your reading result is
equal or lower than your set personalized level a SMILING symbol will
show out and flash on screen.

*

Press and hold "Mode" button to check the pre-set
personalized level.

*

To stop a reading in process, press the "START/STOP" button.

*

The appearance of this symbol, , signifies that a certain pulse
irregularity was detected during the measurement. Talking, moving,
shaking or an irregular pulse during the measurement can result in the
appearance of this icon. Usually this is not a cause for concern, how-
ever if the symbol appears often, we recommend you seek medical
advice. The device does not replace a cardiac examination, but serves
to detect pulse irregularities at an early stage.

Advertising