Sony HDW-M2100 - Manual (Page 18)

Chapter 2
Location and Function of Parts
2-10
Chapter 2 Location and Function of Parts
q; Editing control section
1 DMC EDIT button
Use this button to memorize the playback speed varied
between –1 and +2 times normal speed, and carry out
automatic playback or automatic editing using the
memorized playback speed.
2 MEMORY indicator
When memorizing the playback speed using the DMC
EDIT button, this indicator flashes as the playback
speed is captured to memory, and lights continuously
once the speed is captured.
3 DELETE button
This deletes an existing edit point.
Hold down this button and press the STUNT IN,
STUNT OUT, PLAY IN, or PLAY OUT button which
is lit, indicating an existing edit point, to delete the
corresponding edit point. The button either goes off or
flashes. When the button flashes, it is necessary to set
the deleted edit point again.
To cancel the DMC mode, hold down the DMC EDIT
button and press the DELETE button.
4 TRIM buttons
Use these buttons to trim an edit point to single-frame
precision.
Hold down the STUNT IN, STUNT OUT, PLAY IN,
or PLAY OUT button, and press one of these buttons.
The ‘+’ button advances the corresponding edit point
by one frame, and the ‘–’ button sets it back by one
frame.
Pressing one of these buttons while holding down the
PLAY button adjusts the tape speed by +8% or –8%
correspondingly. (Capstan override function)
5 DMC playback control point setting buttons
PLAY IN button and PLAY OUT button
To set an on-air start or end point, hold down the
PLAY IN button or PLAY OUT button, and press the
ENTRY button.
After you have made the setting, pressing the PLAY
IN button or PLAY OUT button displays the on-air
start or end point set in time data display area 2.
STUNT IN button and STUNT OUT button
To set a speed variation start or end point, hold down
the STUNT IN button or STUNT OUT button, and
press the ENTRY button.
After you have made the setting, pressing the STUNT
IN button or STUNT OUT button displays the speed
variation start or end point set in time data display area
2.
ENTRY button
Use this for setting DMC playback control points and
so on.
• To set a speed variation start or end point: Hold
down the STUNT IN button or STUNT OUT button,
and press this button.
• To set an on-air start or end point: Hold down the
PLAY IN button or PLAY OUT button, and press
this button.
6 CUE/PLAY (cue up/playback) button
After setting an on-air start point (PLAY IN point) or
an on-air end point (PLAY OUT point), pressing this
button cues up the tape to the on-air start point. The
button then starts flashing to indicate that the unit is
ready for DMC playback operation. To start DMC
playback, press the button again.
1 DMC EDIT button
ENTRY
IN OUT
IN OUT
PLAY
DMC EDIT
LEARN CUE/PLAY
DELETE
MEMORY
STUNT
TRIM
2 MEMORY indicator
3 DELETE button
4 TRIM buttons
5 DMC playback control
point setting buttons
7 LEARN button
6 CUE/PLAY button
2-1 Control Panels