Sony HDW-M2100 - Manual (Page 54)

Chapter 6 Tele-File
6-5
Chapter 6
Tele-File
Monitor display
Title
The title (maximum 14 characters) set in attribute data
display/modify mode.
Selected clip number
A 4-digit number representing the number of the
selected clip (with the “*” cursor).
Remaining memory percentage
The percentage of remaining memory (user area)
available for use.
If there is not sufficient free memory, the message
<<MEMORY FULL!!>> appears (stays lit for three
seconds) in time data display area 2 when you attempt
to add data.
Final data recording date
The data (year/month/day) on which data was most
recently recorded.
Data type
The data type. The displayed data is the same as the
data displayed in the menu display section, but some
of the captions are different. There are the following
types.
Cue Point: Cue point
WP: Write protected
Mark: Mark
R: Recording start point
IN Point: IN point
OUT Point: OUT point
Tk: Take number
Cut: Cut number
Scn: Scene number
Comment: Comment
Clip data No. 0001...
Data is displayed for 1 clip per line.
Clips are assigned consecutive numbers, beginning
with No. 0001 for the clip on the top line.
To select clips
Rotate the MULTI CONTROL knob in clip data
display mode.
The data for the selected clip appears in the menu
display section, where it is selected.
In the monitor display, the “*” cursor moves up and
down as clips are selected.
Data which is not visible is selected and displayed
after scrolling.
To select data in a clip
In clip data display mode, press the F3 ( T) or F4 (t)
button.
The “*” cursor moves and data is selected. Data which
is not visible is selected and displayed after scrolling.
2001/07/21 No. 0001 48%
Cue Point WP Mark R
TELE-FILE : TEST 01
00:00:02:10 ON KEEP @
*00:00:31:10
00:00:57:10
Cursor
2001/07/21 No. 0001 48%
Cue Point WP Mark R
TELE-FILE : TEST 01
00:00:02:10 *ON KEEP @
00:00:31:10
00:00:57:10
Cursor
(Scrolling)