Sony HDW-M2100 - Manual (Page 85)

Chapter 9
Setup Menus
Chapter 9 Setup Menus
9-15
Menu items in the range 300 to 399, relating to editing operations (Continued)
Menu items in the range 400 to 499, relating to preroll
337 EXTERNAL REFERENCE
SELECT
338 OUTPUT AUDIO/TC
PHASE Set the audio (AES/EBU and analog) and time code output phase.
HD : Sync with HDSDI output phase.
SD : Sync with SD output phase.
Note
The setting is HD when operating in 24PsF or 23.98PsF mode, and this item is
not displayed.
Select the signal used when this unit is set up by setup menu item 309 and
F2(OUTREF) in function menu page 4 to use an external reference video signal.
HD : Use a high definition reference video signal. Input a three-valued (positive
and negative) sync signal to the REF.VIDEO INPUT connector.
SD : Use a reference video signal. Input a video signal with chroma burst (VBS)
or a monochrome video signal (VS) to the REF.VIDEO INPUT connector.
Note
The setting is HD when operating in 24PsF or 23.98PsF mode, and this item is
not displayed.
Item number Item name
a) When controlled from an editor (BVE-2000/9100 etc.),
selecting “REEL” allows high-speed cuing up.
Settings
Item number Item name Settings
401 FUNCTION MODE
AFTER CUEUP Select the state that the unit goes into after a cuing-up operation.
STOP : Stop (the “stop mode”)
STILL: Still playback (in search mode)
Note
When controlling this unit from an editor with the standard constants set, select
“STOP”.
402 TIME REFERENCE FOR
PREROLL When prerolling a tape with time code discontinuities, select whether or not to use
CTL pulses to count time code from before a discontinuity.
CTL : Use CTL pulses to count time code.
TC: Do not use CTL pulses to count time code.
403 AUTOMATIC PREROLL
REFERENCE ENTRY Select whether or not the edit IN point is automatically set by pressing the
PREROLL button, when the IN point is not set before starting preroll.
DIS : IN point is not set automatically.
ENA: IN point is set automatically.
405 CUEUP BY CTL Select the tape transport mode when cuing. This setting is valid only when the
function menu item CTL/TC is set to CTL.
CAP. : During cuing up, the tape transport is in the “pinch ON” state (maximum
tape speed 10 times normal).
REEL : During cuing up, the tape transport is in the “pinch OFF” state. As the
tape approaches the cue up point and the tape speed drops, the tape transport
switches to the “pinch ON” state.
a)
To give priority to editing accuracy, select “CAP”.