Sony HDW-M2100 - Manual (Page 88)

Chapter 9
Setup Menus
9-18
Chapter 9 Setup Menus
9-4 Items in the Extended Setup Menu
Menu items in the range 600 to 650, relating to the time code generator (Continued)
Menu items in the range 651 to 699, relating to the UMID
Item number Item name Settings
621 24F STARTING TC SEL
(In 50i or 25PsF mode
only. Not displayed when
operating in 720P-line
mode.) Select one of the following settings for time code conversion from 24F to 25F.
OFF : Do not set the starting TC
ON: Set the starting TC
To set the 24F starting TC
Press the F5 (SET) button with this menu item displayed in the menu display, to
enter the starting TC setting mode. You can then set the user starting TC digit by
digit using the F1 (PREV) button and F2 (NEXT) buttons for digit selection. When
all required digits have been set correctly, press the F5 (SET) button again to
save the starting TC and exit from the ID code setting mode.
25F STARTING TC SEL
(In 24PsF or 23.98PsF
mode only. Not displayed
when operating in 720P-
line mode.) Select one of the following settings for time code conversion from 25F to 24F.
OFF : Do not set the starting TC
ON: Set the starting TC
To set the 25F starting TC
Press the F5 (SET) button with this menu item displayed in the menu display, to
enter the starting TC setting mode. You can then set the user starting TC digit by
digit using the F1 (PREV) button and F2 (NEXT) buttons for digit selection. When
all required digits have been set correctly, press the F5 (SET) button again to
save the starting TC and exit from the ID code setting mode.
622 24F JUMPING TC SEL
(In 50i or 25PsF mode
only. Not displayed when
operating in 720P-line
mode.) Select one of the following settings for time code conversion from 24F to 25F.
–3H : Set JUMPING TC to “STARTING TC –3H”.
–2H : Set JUMPING TC to “STARTING TC –2H”.
–1H : Set JUMPING TC to “STARTING TC –1H”.
+1H : Set JUMPING TC to “STARTING TC +1H”.
+2H : Set JUMPING TC to “STARTING TC +2H”.
+3H : Set JUMPING TC to “STARTING TC +3H”.
0H : Set JUMPING TC to “STARTING TC”.
25F JUMPING TC SEL
(In 24PsF or 23.98PsF
mode only. Not displayed
when operating in 720P-
line mode.) Select one of the following settings for time code conversion from 25F to 24F.
–3H : Set JUMPING TC to “STARTING TC –3H”.
–2H : Set JUMPING TC to “STARTING TC –2H”.
–1H : Set JUMPING TC to “STARTING TC –1H”.
+1H : Set JUMPING TC to “STARTING TC +1H”.
+2H : Set JUMPING TC to “STARTING TC +2H”.
+3H : Set JUMPING TC to “STARTING TC +3H”.
0H : Set JUMPING TC to “STARTING TC”.
651 UMID OUTPUT Select UMID output and the UMID type.
off : Do not output UMID.
BASIC: Output Basic UMID.
EXTND: Output Extended UMID.
Notes
• Even if EXTND is selected, Basic UMID is output if Basic UMID is recorded on
the tape being played back.
• When operating in 720P active scan line mode, UMID is not output.
Item number Item name Settings