Sharp 20F630 L - Manual (Page 31)

31
Dimension: 140mm x 215mm
Parental Control (V-CHIP Operation Continued)
L Turning On (Activating) the V-Chip Blocks
1
Repeat steps 1 to 3 of [1] MPAA RATING.
2
Press VOL (+) or (–) to access V-CHIP BLOCK select mode, then
press CH UP (8) or DOWN (9) to move the “a” mark to “SECRET
No.”.
3
Enter a 4-digit SECRET No. using the REMOTE KEYPAD .
4
Press CH UP (8) or DOWN (9) to move the “a” mark to “STATUS”,
then press VOL (+) or (–) to activate the V-CHIP BLOCK. (If STATUS
is OFF, V-CHIP BLOCK will not operate.)
5
When done, press MENU to exit.
L To cancel the V-CHIP BLOCK screen while V-CHIP BLOCK has been activated.
1
“V-CHIP HAS BEEN ACTIVATED” will be displayed if you view a
program containing Program Rating data as same as you
configured.
Note:
• “V-CHIP HAS BEEN ACTIVATED” will not be displayed if STATUS is
not configured to “ON”.
2
Press MENU , then “INPUT SECRET No.” will be displayed.
3
Enter the 4-digit SECRET No. using the REMOTE KEYPAD , then
V-CHIP BLOCK temporarily will be canceled. If the wrong SECRET
No. is chosen, “SECRET No. IS INCORRECT” will be displayed.
Input the SECRET No. again in this case.
Note:
• If you turn the power from OFF, the V-CHIP BLOCK will automatically reset to ON again.
V – C H I P OC K L B
MP A A
T V U G I
OP O I N T
D E L I N E S
S E C E R T – – N o .
S T A U T S O : F F
: – –
(V-CHIP BLOCK select mode)
CH
8
9
CH
; :
VOL
–
VOL
+
V – C H I P OC K L B
MP A A
T V U G I
OP O I N T
D E L I N E S
S E C E R T 3 4 N o .
S T A U T S O : F F
: 1 2
; :
VOL
–
VOL
+
→
CH
8
9
CH
MENU
→
3 2 1
6 5 4
9 8 7
0
V – C H I P OC K L B
MP A A
T V U G I
OP O I N T
D E L I N E S
S E C E R T 3 4 N o .
S T A U T S O : F F
: 1 2
MENU
2 3
V – C I H P
A C V I A E T D T
H A S B E EN
T V – Y 7
F V
I N P T U S
– – – –
E E CR T o N .
I N P T U S E E CR T o N .
∗ ∗ ∗ ∗
3 2 1
6 5 4
9 8 7
0
20F630[31-35].p65 25/3/03, 2:59 PM 31