Sharp R520_CJ16_MM_111009_F4 - Manual (Page 106)

103
1. At the Tools menu, select Voice SVC.
The following options appear in the display:
• Voice Commands — Lets you place calls, access the Contacts
List, review appointments, and more by speaking commands into
the phone. (Also see “Making a Call — Voice Dialing” on
page 23 and “Voice Method” on page 40 for more information.)
• Voice Settings — Lets you adjust VoiceSignal settings.
2. Select the desired sub-menu.
Voice Commands
To start VoiceSignal, do one of the following:
• In Standby mode, press and hold .
“Say a Command” appears in the display and is pronounced through
the earpiece, followed by a list of available commands.
• At the Tools menu, select Voice SVC ➔ Voice Commands.
Note: You can set the phone to start VoiceSignal when you open the phone.
(For more information, refer to “Voice Launch” on page 106.)
VoiceSignal includes the following commands:
– Call — Lets you dial the phone by saying any name stored in the
contact list, without ever having to record, or “train” that name.
VoiceSignal automatically voice-activates all the contacts, even if you
have hundreds of them stored on the phone. You can also dial any
telephone number, even if it is not stored in the contact list, by saying
the digits in the number. (For more information, refer to “Making a
Call — Voice Dialing” on page 23..)
– Send Text — Lets you launch the Create Txt Msg screen. (For more
information, refer to “Create and Send Text Messages” on
page 51..)
– Send Picture — Lets you launch the Create Pic Msg screen. (For
more information, refer to “Send Picture / Video Messages in
Standby Mode” on page 55.)
– Lookup — Lets you look up and display contact information for any
name stored in the Contacts list by saying the name. (For more
information, refer to “Finding a Contacts Entry” on page 39..)
– Go to — Lets you access all of the Main Menus on the phone.
– Check — Lets you check the phone's status (that is, network
coverage, signal strength, and battery in the same report), network
coverage, signal strength, battery, and phone number.
Note: Speaking clearly, say the command that you want to use.
If, after a few seconds, the device has not recognized a command, it
prompts you to repeat the command.
If, after a few more seconds, it still has not recognized a command, it
tells you “Sorry, no match found,” and cancels voice recognition.
Voice Command Tips:
• Make sure you wait for the beep before speaking.
• Speak clearly at a normal volume, as if you were talking on the phone.