Sharp R520_CJ16_MM_111009_F4 - Manual (Page 44)

41
• If VoiceSignal does not recognize the name you said, a choice list of
up to three names appears in the display, and VoiceSignal prompts
you with “Did you say?” followed by the first name on the list.
4. Say “Yes” to confirm the name or “No” to hear the next
name, or use the keypad to select the correct name from
the list. (For more information, refer to “Choice Lists” on
page 104)
• To say the name again, press Repeat.
• To exit VoiceSignal without dialing, press Settings and press Exit.
5. The contact information for the name you selected appears
in the display.
• To dial the default number associated with the name, press .
• To remove this entry from your Contacts list, press the Erase soft
key.
• To add or change information for this entry, press EDIT ( ).
• To access the following options, press the Options soft key.
– Send Message — Create and send a Text/Picture/Video message to
the selected Contact.
– Call — Dial the number associated with the Contact name.
– Send Name Card Via Bluetooth — Send the select Contact’s
information to another Bluetooth device.
Quick Search Method
For information on enabling Quick Search, see “Quick Search” on
page 128.
1. In Standby mode and with Quick Search enabled, press the
first few numeric keys that correspond to the letters of the
Contact’s name.
Example: To search for “Sally” you would enter 725.
2. Press the Up navigation key. A list of Contact names that
begin with letters corresponding to the number keys you
pressed appears in the display.
3. Highlight the searched for Contact.
• To call the Contact, press .
• To view the Contact, press .
Adding a New Contacts Entry
You can use either of two methods to add an entirely new entry to
Contacts.
Dial Method
1. Using the keypad, enter the number you wish to add to
your Contacts.