Sony KLV-40U100M - Manual (Page 19)

Connecting the Unit
19
Co
nnec
ting the
Un
it
KLV-32U100M
2-668-009-13(1)
G:\#Sagyo\SONY\09 TV\kaihan KLV-
32U100M\1219_KLV32U100M_rev\2668009131\2668009131 KLV-
32U100M_US\01US04INS.fm masterpage:3 columns Right
VCR and Cable
This scenario shows a VCR with Cable signals connected through the video
inputs. The Cable or VCR signals are selected by the VCR through the video
inputs.
To connect the VCR and cable
1 Connect the CATV cable to the VCR’s VHF/UHF input jack.
2 Use an A/V and S VIDEO cables to connect the VCR’s AUDIO and
S VIDEO output jacks to the unit’s AUDIO and S VIDEO input jacks
(VIDEO 1 or 2).
Notes on Using This Connection
If your VCR is not equipped with S VIDEO, use a VIDEO cable
(yellow) instead of the S VIDEO cable.
VIDEO IN
1
VIDEO
AUDIO
L
R
(MONO)
S VIDEO
A/V cable
CATV cable
VCR
S VIDEO
VIDEO
(yellow)
AUDIO-L
(white)
AUDIO-R
(red)
S VIDEO cable
Rear of unit
To Do This ... Do This ...
Watch the VCR or cable channels Press V1 or V2 on the remote control.
or
Press INPUT on the top panel repeatedly to select the VCR input (VIDEO 1 or 2).
Label video inputs to easily
identify equipment connected to
the unit See the instructions for setting up Label Video Inputs on page 40.
01US02WAR-UC.book Page 19 Monday, December 19, 2005 1:58 PM