Sony SNC-CS20 - Manual (Page 47)

A
d
mini
s
tra
ting
t
he
Came
ra
Configuring the Network — Network Menu
47
Note
When you have set the HTTP port number to a number
other than 80 in the Network menu or in the IP Setup
Program, access the camera again by typing the IP
address of the camera on your Web browser as follows:
Example: when the HTTP port number is set to 8000
OK/Cancel
See “Buttons common to every menu” on page 28.
Dynamic IP address notification
Tab — Notifying the IP Address
When Obtain an IP address automatically (DHCP) is
selected in the Network tab, you can send notification of
completion of the network settings using the SMTP or
HTTP protocol.
e-Mail (SMTP) notification
Select On to send an e-mail when the DHCP setting is
completed.
SMTP server name
Type the name or IP address of the SMTP server for
sending an e-mail, using up to 64 characters.
Authentication
Select the authentication required when you send an e-
mail.
Off: Select if no authentication is required when an e-
mail is sent.
On: Select if authentication is required when an e-mail
is sent. Select one of the authentication methods
from the following and specify the POP server
name, User name and Password as required.
SMTP: Select when SMTP authentication is
required.
POP before SMTP: Select when POP before SMTP
authentication is required.
Note
When you set Authentication to On, make sure to select
either or both SMTP or/and POP before SMTP.
POP server name
It is necessary when POP before SMTP is selected for
Authentication.
Type the POP (receiving mail) server name using up to
64 characters. Or type the IP address of the POP server.
This setting is necessary when the SMTP server that
sends e-mails performs authentication using the POP
user account.
User name, Password
Type the user name and password of the user who owns
the mail account using up to 64 characters. This setting
is necessary when the SMTP server that sends e-mails
performs authentication.
Recipient e-mail address
Type the recipient e-mail address using up to 64
characters. You can specify only one recipient e-mail
address.
Administrator e-mail address
Type the e-mail address of the camera administrator
using up to 64 characters. This is used as the reply
address or the address for a system mail from the mail
server.
Subject
Type the subject/title of the e-mail using up to 64
characters.
Message
Type the text of the e-mail using up to 384 characters. (A
line break is equivalent to 2 characters.) You can
describe the information of the acquired IP address, etc.
using the special tags mentioned below.