Sharp SND-5080 User Manual

Page 25

Advertising
background image

English _25

M

INSTALLATION & CONNECTION

To fix the camera position, hold down either
hook of the inner cover and lift it up.

Push the release lock out while turning the main unit in
the <UNLOCK> direction to remove the bracket.
If this doesn't work, use the hole on the bottom of the
bracket to turn the bracket in the <LOCK>direction.

Use the provided screws (x3) to fix the bracket to a
desired position (ceiling or wall).

Ensure that the <CAMERA FRONT> label on the bracket faces
the direction for camera monitoring.

Arrange the cables through the bracket to the
ceiling or wall.
If you drill a hole in the ceiling cover for wiring,
press hard to remove the cover and attach the
dust-proof plate to it, and arrange the cables
through the plate. If you intend to arrange the
cables without drilling a hole, use the empty
area opposite to the <CAMERA FRONT>
label side for the wiring purpose.

Mount the main unit onto the bracket.
Align the marking hole of the main unit with the
<CAMERA FRONT> label of the bracket, and
turn the unit in the <LOCK> direction.

Adjust the lens in a desired direction.
For adjusting the lens direction, refer to "Adjusting the monitoring direction for
the camera". (page 31)

Secure the inner cover to the main unit.
Fit the two holes of the wing-side locks on the inner cover into the corresponding
hole of the main unit, and press it down until you hear a click.

Fix the cover to the main unit.
Fit the protruding part inside the cover into the corresponding hole of the main unit,
and turn the cover to fix it.

2.

3.

4.

5.

6.

7.

8.

9.

Wiring Cover

Advertising