Sharp SND-5080 - Manual (Page 48)

48_ network connection and setup
network connection and setup
In the <Address> pane, provide the
necessary information.
MAC (Ethernet) Address : The MAC
(Ethernet) address of the applicable
camera will be set automatically so you
don't need to input it manually.
If using an IP router
IP Address : Enter an address falling in
the IP range provided by the IP router.
ex) 192.168.1.2~254,
192.168.0.2~254,
192.168.XXX.2~254
Subnet Mask : The <Subnet Mask> of
the IP router will be the <Subnet Mask>
of the camera.
Gateway : The <Local IP Address> of
the IP router will be the <Gateway> of the camera.
The settings may differ depending on the connected IP router model.
For more information, refer to the user manual of the applicable router.
If not using an IP router :
For setting <IP Address>, <Subnet Mask>, and <Gateway>, contact your network
administrator.
In the <Port> pane, provide
necessary information.
HTTP Port : Used to access the
camera using the Internet browser,
defaulted to 80. Use the spin button
to change the HTTP Port value.
VNP Port : Used to control the video
signal transfer, defaulted to 4520.
Enter the password.
This is the login password for the "admin" user who accesses the camera.
The default password is "4321".
Click [OK].
Manual network setup will be completed.
When the manual setup including <IP> is completed, the camera will restart.
3.
y
y
y
M 
4.
y
y
5.
6.
7.