Samsung SV-DVD3E EN - Manual (Page 6)

GB
Connecting DVD-VCR to the TV using the Coaxial Cable
Connecting DVD-VCR to the TV using the RCA Cable
11
GB
Deciding How to Connect DVD-VCR
10
To receive television programmes a signal must be received from
one of the following sources:
◆ An outdoor aerial
◆ An indoor aerial
◆ A cable television network
◆ A satellite receiver
☛
Make sure that both the television and the DVD-VCR are
switched off before connecting the cables.
1 Remove the aerial or network input cable from the television.
2 Connect this cable to the 75 Ω coaxial socket marked on the
rear of your DVD-VCR.
3 Plug the coaxial cable supplied into the socket on your
DVD-VCR.
4 Plug the other end of the coaxial cable into the connector
previously used for the aerial on the television.
5 To obtain better quality pictures and sound on your television, you
can also connect your DVD-VCR to the television via the RCA
cable (see section below) if your television is equipped with this
type of connection.
TV
You must take into account various factors when connecting audio or video systems:
◆ Types of connectors available on your systems
◆ Systems connected permanently to the DVD-VCR (satellite receiver for example) or
temporarily (camcorder for example)
Your DVD-VCR is equipped with the following connectors.
Connector Location Type Direction Recommended Use
LINE Rear Audio/Video RCA In/Out ◆ Television
◆ Other VCR
Audio output Rear Audio RCA Out ◆ Audio out (DVD only)
COMPONENT Rear RCA Out ◆ COMPONENT out (DVD only)
output
S-VIDEO Rear S-JACK Out ◆ S-Video out (DVD only)
output
Digital AUDIO Rear Optical Out ◆ Digital Audio out (DVD only)
output coaxial
OUT TO TV Rear 75 Ω Out ◆ Television
coaxial
IN FROM ANT. Rear 75 Ω In ◆ Aerial
coaxial ◆ Cable television network
◆ Satellite receiver
☛
Whenever you connect an audio or video system to your DVD-VCR, ensure that all elements
are switched off.
Refer to the documentation supplied with your equipment for detailed connection instructions
and associated safety precautions.
DVD & VCR
DVD & VCR
3
2
TV
4
DVD & VCR
Aerial
RF coaxial cable
2
3
TV
You can connect your DVD-VCR to the television using the RCA cable if the appropriate input is available
on the television. You thus:
◆ Obtain better quality sound and pictures
◆ Simplify the setting up procedure of your DVD-VCR
☛
◆ Regardless of the type of connection chosen, you must always connect the coaxial cable supplied.
Otherwise, no picture will be visible on the screen when the DVD-VCR is switched off.
◆ Make sure that both the television and the DVD-VCR are switched off before connecting the cables.
1 Connect the coaxial cable as indicated in the above section.
2 Connect one end of the RCA Audio/Video cable to the Video output and Audio L, R output socket on the rear
of the DVD-VCR.
3 Plug the other end into the appropriate connector on the television.