Sony SX-215 - Manual (Page 10)

User’s Guide
Print Server Components
The print server includes the following components. Detailed descriptions of these components are
provided below:
 Power connector – The power supply cable plugs into this connector.
 Test button – Pressing this button for less than three seconds will print a test page on the
printer. Pressing and holding this button for more than five seconds will reset the print server to
factory default settings.

LED status indicators – used to indicate the operational states of the print server. Refer
to the LED status light descriptions on the next page.

Ethernet Port – This port is used for connecting the print server to a 10/100Base-TX
Ethernet card, hub, router, or other wired access point for network access.

Parallel port – The parallel port is used for connecting the print server to the IEEE 1284-
compliant parallel port of your printer (parallel port models only).

USB port – The USB port is used for connecting the print server to the USB 2.0 port of
your printer. You must use a standard USB A (print server side) to B (printer side) cable (USB port
models only).
Document #40181-420 Rev. B 10
NOTE: A USB 2.0 cable must be used to take full advantage of the high-speed USB 2.0 connection.