Sony SX-215 - Manual (Page 13)

User’s Guide
Section 2 – Hardware Installation
Before You Begin
Before installing the print server, make sure you have installed and set up your printer as described in the
documentation that came with the printer and that your printer functions properly. SX-200 Series Print
Servers support a parallel and/or USB connection to your printer.
Hardware Installation
(wired and wireless versions)
1. Write down the 12-digit MAC address printed on the label located on the bottom of the print
server (for example: 004017023F96). You may need this number in order to configure the print
server.
2. Mount the print server on either the printer or the desktop:
 Printer mount – attach the print server to a suitable location on the side or rear of your
printer by applying an adhesive Velcro strip (provided in the printer mounting kit) to your printer
and at the top of the print server as it is to be attached to your printer.
 Desktop mount – attach the adhesive rubber feet (provided in the desktop mounting kit) to the
bottom of the print server as shown below.
Document #40181-420 Rev. B 13
NOTE: Be sure to review the hardware requirements in the previous section to ensure you have the necessary
information before installing the print server.