Sony SX-215 - Manual (Page 68)

User’s Guide
Firmware Update
These commands set up the unit for performing an update of the server firmware.
SET LOAd ENable
If enabled, the firmware performs a soft reset and enters the server boot program after the next EXIT command.
This command should not be used with the Serial Server. It remains in the firmware for diagnostic use.
SET LOAd (ENable | DIsable ]
(default = disable)
SET LOAd HOst
Set the node name of the Netware boot host. Note that netware download is not supported on the Serial Server, so
this command should not be used.
SET LOAd HOst <name>
(default = <null>)
SET LOAd IP
Set the IP address of the source computer for a TFTP get operation.
SET LOAd IP aa.bb.cc.dd
(default = 0.0.0.0)
SET LOAd SOftware
Set filename on host for TFTP get update.
SET LOAd SOftware <filename>
SET LOAd TFTP
Initiate firmware update via a TFTP get operation. The TFTP server address must be set via SET LOAd IP and the
filename via SET LOAd SOfware. The server will reset after the firmware update is completed.
SET LOAd TFTP
SET LOAd XModem
Initiate firmare update via the serial console using the XModem protocol. The server will reset after the firmware
update is completed.
SET LOAd XModem
Document #40181-420 Rev. B 68