Samsung SCX-RD100 - Manual (Page 15)

English 15
ENG
Connection & Control
TO CONTROL THE CAMERA USING RS-485 SIGNAL
OUTPUT
Connect the product to DC 12V power source or insert 4 AA-sized
batteries into the battery compartment.
Set the protocol switches 7 and 8 to OFF.
Connect the RX(+/-) of the unit to the RS-485 (+/-) port of the camera.
Match the camera’s address, baud rate, and protocol to the same to
those of the unit.
Now you can control the camera by using the menus.
You can use the menu as following :
Press and hold [ENTER]: Moves to the main menu screen.
To exit the menu screen, press and hold the key again.
Press [ENTER] briefl y: Used to confi rm the current settings.
Four Direction Keys: Used to move the cursor up/down or left/right.
Control of pan/tilt/zoom using the buttons is not supported.
1.
2.
3.
4.
5.
❖
–
–
–
–
ADDRESS (X)100 (X)10 (X)1
POWER
OFF ON
CABLE COMPENSATION
S L
REMOTE CONTROLLER SCX-RD100
POWER STATUS
TERMINATION PROTOCOL
1 ON 2345678 1 ON 2
Input of video signal is required to control RS-485.
The next time you access the menu, press and hold the [ENTER] key twice.
ƒ
ƒ
NOTE