Remote commander others error messages – Sony STR-DN1010 User Manual

Page 128

Advertising
background image

128

GB

D:\NORM'S JOB\SONY HA\SO0087\STR-DN1010_PMRF\GB\GB07ADD_STR-DN1010-CEL.fm

masterpage: Left

STR-DN1010

4-174-068-12(1)

Radio stations cannot be tuned in.

• Check that the antennas (aerials) are

connected securely. Adjust the antennas
(aerials) and connect an external antenna
(aerial), if necessary.

• (Models of area code U2, CA2 only)

Keep the satellite radio antenna, away
from the speaker cords and the power cord
to avoid picking up noise.

• The signal strength of the stations is too

weak (when tuning in with automatic
tuning). Use direct tuning.

• Make sure you set the tuning interval

correctly (when tuning in AM stations
with direct tuning).

• No stations have been preset or the preset

stations have been cleared (when tuning
by scanning preset stations). Preset the
stations (page 55).

• Press AMP, then press DISPLAY

repeatedly on the remote so that the
frequency appears on the display.

The receiver cannot receive satellite
channels at all.

a)

• The receiving condition is not good. Move

the antenna to the place where the
condition is good.

• Check that you subscribed to the satellite

radio service you want (page 57).

RDS does not work.

b)

• Make sure that you are tuned to an FM

RDS station.

• Select a stronger FM station.

The RDS information that you want
does not appear.

b)

• Contact the radio station and find out

whether they actually provide the service
in question. If so, the service may be
temporarily out of order.

a)

Models of area code U2, CA2 only.

b)

Models of area code CEK, ECE, AU1, TW2 only.

The remote does not function.

• Point the remote at the remote sensor on

the receiver.

• Remove any obstacles in the path between

the remote and the receiver.

• Replace all the batteries in the remote with

new ones, if they are weak.

• Make sure you select the correct input on

the remote.

• When you operate a programmed non-

Sony component, the remote may not
function properly depending on the model
and the maker of the component.

The receiver is turned off
automatically.

• The “Auto Standby” function is working

(page 100).

If there is a malfunction, the display shows a
message. You can check the condition of the
system by the message. See the following table
to solve the problem. If any problem persists,
consult your nearest Sony dealer.

PROTECTOR

Irregular current is output to the speakers, or
upper panel of the receiver is covered with
something. The receiver will automatically
turn off after a few seconds. Check the
speaker connection and turn on the power
again.

Remote commander

Others

Error messages

Advertising