Schumacher 600A - Manuel (Page 10)

10
Read this entire manual before using your charger. The tips below serve only as a
guide for specific situations.
CHARGING TIPS
Reviving your battery: If you only wish
to charge your battery enough to start
your vehicle, you do not need to wait for
the entire charging process to be
completed. When the battery status
displays 3 yellow LEDs the battery has
usually been charged enough for the
vehicle to start normally. Completing an interrupted charge: If
the charging process has been inter-
rupted and restarted after the charger
displays a battery status of 4 yellow
LEDs, the charger may enter Maintain
Mode (see previous page). However, if
the original charge was started using
6A, the charge can often be completed
using the 2A rate.
MAINTENANCE AND CARE
A minimal amount of care can keep your battery charger working properly for years.
1. Clean the clamps each time you are finished charging. Wipe off any battery fluid
that may have come in contact with the clamps to prevent corrosion.
2. Coil the input and output cords neatly when storing the charger. This will help
prevent accidental damage to the cords and charger.
3. Occasional cleaning of the case of the charger with a soft cloth will keep the finish
shiny and help prevent corrosion.
4. Store the battery charger in a clean and dry location.