Resetting the lamp timer, 2regarding the lamp (continued) – Sharp PG-D3510X User Manual

Page 66

Advertising
background image

62

4

Remove the lamp unit.

Loosen the securing screw from the lamp
unit. Hold the lamp unit and pull it in the
direction of the arrow. At this time, keep
the lamp unit horizontal and do not tilt it.

5

Insert the new lamp unit.

Press the lamp unit fi rmly into the lamp unit
compartment. Fasten the securing screw.

6

Replace the lamp unit cover.

Align the tab on the lamp unit cover
(1) and close it (2). Then tighten the user
service screw (3) to secure the lamp unit
cover.

Info

If the lamp unit and lamp unit cover
are not correctly installed, the power
will not turn on, even if the power
cord is connected to the projector.

Resetting the Lamp Timer

Reset the lamp timer after replacing the lamp.

Info

Make sure to reset the lamp timer only when
replacing the lamp. If you reset the lamp timer
and continue to use the same lamp, this may
cause the lamp to become damaged or
explode.

1

Connect the power cord and

open the lens shutter fully.

Plug the power cord into the AC socket of
the projector.

2

Reset the lamp timer.

While simultaneously holding down
MENU, ENTER and

R

on the projector,

press STANDBY/ON on the projector and
keep all four buttons pressed down until
the lamp indicator starts blinking green.
“LAMP 0000H” is displayed, indicating
that the lamp timer is reset.

4

Securing
screw

Securing
screw

5

6

AC socket

AC socket

1

ENTER button

MENU button

R button

STANDBY/ON
button

ENTER button

MENU button

R button

STANDBY/ON
button

2

Regarding the Lamp (Continued)

Advertising
This manual is related to the following products: