Shure SCM410E - Manual (Page 5)

5
INSTALLATION
SUPPLIED HARDWARE
S
4 rubber feet
S
1 rackmount bracket, long
S
1 rackmount bracket, short
S
2 straddle brackets
S
10 bracket screws, 6 mm (1/4 in.)
S
4 rackmount screws, 2.54 cm (1 in.)
S
4 plastic washers
S
4 wood screws, 1.25 cm (1/2 in.)
RACK MOUNTING
The SCM410 is supplied with hardware for mounting one or
two units to a 19-inch audio equipment rack. The hardware can
also be used to rack mount other Shure products, including the
SCM268, SCM262, DFR11EQ, and the DP11EQ.
Single Mixer (Half Rack) Installation
1. Attach the short and long rackmount brackets to the
SCM410/E with eight (8) of the supplied bracket screws, as
shown in Figure 4.
INSTALLING HALF–RACK MOUNTING BRACKETS
FIGURE 4
2. Place the mixer in an equipment rack and secure it with
the supplied rackmount screws and plastic washers. See
Figure 5.
RACK MOUNTING A SINGLE SCM410/E MIXER
FIGURE 5
Dual Mixer (Full Rack) Installation
1. Place the two mixers side-by-side and connect them with
two (2) straddle brackets. The brackets should straddle the
recessed edges on the top and bottom of each mixer. See
Figure 6.
INSTALLING STRADDLE BRACKETS
FIGURE 6
2. Fasten the straddle brackets using eight (8) bracket screws.
3. Attach the short rackmount brackets to the outsides of the
combined mixers with eight (8) of the bracket screws. See
Figure 7.
INSTALLING FULL–RACK MOUNTING BRACKETS
FIGURE 7
4. Place the mixer in an equipment rack, using the supplied
rackmount screws and plastic washers. See Figure 8.
RACK MOUNTING DUAL SCM410/E MIXERS
FIGURE 8